PEYAL
|
Quick change Tool-post set for lathes |
To
obtain the best efficiency in small or large productions runs in your
horizontal lathe, the QUICK CHANGE TOOLPOST "PEYAL" is the indispensable
accessory. At
removing a tool on the toolposts, it return to his original position.
The positioning do not exceed on 0.03 mm (.0012") from his original calibration.
The ground and controlled prisms by means of gages, warranty a exactly
and external dimensions on the workpieces. The vertical movement is done
by means of a screwed regulator and a locking screw. It permit a fine
adjustment and allows putting in place the toolholders in the same position.
REPETITION OF OPERATIONS WITHOUT CHANGE OF DIMENSIONS. |
(1678) Caseros Buenos Aires Argentina Tel./Fax: 0054-11-4750-3345 0054-11-4759-7198 Movil: 15-4411-9536 E-mail: ditoma@ditoma.com.ar
|
|
6 January, 2003